Associated Gaskets

Associated Gaskets

1300 098 060

Call us

6 Locations Around Australia

Get contact information for your local branch

Weiconlock AN 306-48 Cylindrical Assembly Sealer

Material AG000512S01 Category

Weiconlock AN 306-48 Cylindrical Assembly Sealer

A high strength, high temperature resistant grade of anaerobic adhesive that has been approved by BAM for oxygen service.

Typically used for the permanent bonding, locking and sealing of all kinds of bearings, shafts, bushings and other cylindrical assemblies.

Weiconlock AN 306-48 Cylindrical Assembly Sealer is a high quality, high temperature resistant grade of anaerobic adhesive that has been approved by BAM for oxygen service. This grade of adhesive cures with high strength which means that connections locked and sealed with AN 306-48 will be hard to disassemble without the use of solvents.

Weiconlock AN 306-48 Cylindrical Assembly Sealer is typically used for the permanent bonding, locking and sealing of all kinds of bearings, shafts, bushings and other cylindrical assemblies.

Technical Details
Colour Yellow
For Threaded Joints Up To M 20
Viscosity at 25ºC Brookfield 550 mPa
Gap filling capacity (max.) 0.15mm
Breakaway Strength (Thread) 30 – 35 Nm
Prevailing Strength (Thread) 55 – 70 Nm
Shear Strength (DIN 54452) 25 – 35 N/mm²
Handling Strength at Room Temp. 5 min. (approx.)
Final Strength at Room Temp. 2-4 Hours
Temperature Resistance -60ºC to +175ºC
 
Available Sizes

Weiconlock AN 306-48 Cylindrical Assembly Sealer is available from your local Associated Gaskets branch in 20ml, 50ml or 200ml bottles. These special pen shaped bottle allow for easy, accurate application while the base minimises the chances of any spillage.

Surface Preparation

In most applications, Weiconlock AN 306-48 Cylindrical Assembly Sealer does not require pre-treatment of the surface as even slightly oily surfaces cab still be adhered. That being said, best results will be achieved on cleaned and degreased surfaces (Weicon Surface Cleaner is ideal for this task). If required the parts should be slightly roughened.

Processing

Weiconlock AN 306-48 is ready to use from the moment you open the bottle. It should be evenly applied direct from the bottle/tube with the dispensing tip (avoid direct contact between the dispensing tip and metal). Weiconlock AN 306-48 should be applied evenly around the thread.

Do not pour any excess Weiconlock fluid that has made contact with metal back into the bottle. Even the smallest metal particles will cause the contents of the bottle to cure once the lid is re-closed. In series construction or production line situations, the use of manual or automatic applicators is suggested. For full use instructions, please consult the TDS & SDS for this product (both of which can be provided by your local AG branch).

Adhesive Finder Tool

Unsure if this adhesive is suitable for your application? Try Weicon’s handy Adhesive Finder tool!

Colour

Max. Continuous Temp.

Min. Continuous Temp.

One or Two Part Glue

Threadlocker Viscosity

Threadlocker Strength

For Threaded Joints Up To…

Max. Gap Filling Capacity

100% Cure

Viscosity

Any Approvals for Water / Food

Approved for Gas

Approved for Oxygen Sealing

Dangerous Goods for Transport

Brand